Design your own

Length runs along the front edge, and depth goes from the front edge to the back. Thickness is the edge you see.

Every edge is rounded to a 3 mm radius, softer under your hand and less likely to chip than a sharp edge. There's no charge.

A drop edge folds down along the front, back or sides, so a 30 mm top can look 60 mm thick or more from the room. Height is measured from the top surface down.

The top runs down to the floor at one or both ends, 900 mm from the top surface, cast in one piece.

Each cut-out is set out to its centre, measured from the left end and from the front edge. Use the cut-out size in your sink, basin or hob's fitting instructions. It isn't the outside size.